No LAN connection you will need to troubleshoot why you do not have connectivity.įor more information on aligning and bandwidth testing your Ubiquiti Point to Point bridge please view this article Ubiquiti Antenna Alignment and Link Performance. Note: If you cannot login to the Rocket Prism GEN2 AP (Access Point that currently has PoE only i.e.
The dashboard screenshot above shows both station radios connected. You will have created a Point to Multipoint Bridge with 1x AP and 2x Client Radios (Stations). Repeat from Step 4, remembering to give the device a unique managment IP address, ie 192.168.1.202 for the Power beam 5AC-Gen2. Step 8: Configuring the next client Radio Verify the point to multi-point bridge has been configured successfully by logging into the AP Radio and checking the connection status on the Dashboard, you can see the station radios connected from the AP Radio: Select Save Changes at the bottom of the page to apply all configurations made in Steps 4-6. no LAN connection.Ĭonnect the first client radio NBE-5AC-GEN2(Station) to your laptop or network and navigate to the Wireless tab.Ĭlick the Select button next to the SSID field.Ĭlick the radio button next to your SSID (my_wds_bridge) and the press Select. Select Save Changes at the bottom of the page to apply all configurations made in Steps 1-3.īefore proceeding confirm that your settings have saved by connecting to 192.168.1.200 in your web browser, then unplug the Rocket Prism Radio and re-locate it to the other side of you work room and connect the Power ( PoE ) only i.e. Time Zone: (GMT+12:00) Auckland, Wellington, Fiji, KamchatkaĬlick the Change Password button to update the username and password. On the Network tab make the following changes. Channel Width and Center Frequency, MHz can also be adjusted to suit your application and environment - be aware though that these changes must be matched on the client radios (Stations). The SSID & WPA Preshared Key settings are an example and should be customised to secure your network. Plug in the Rocket 5AC Gen2 Prism (Access Point) to your laptop or network and make the following changes under the Wireless tab. If this is not the case please refer to " Logging in to a Ubiquiti Wireless Access Point or Router ".
This article assumes you know how to login to a Ubiquiti radio. It is also possible to use the older Airmax OS6 M5 Radios as client/station radios only if you have some older legacy gear to re-use. This same configuration can be used for any of the AirMAX AC products (NanoBeam AC, PowerBeam AC, PowerBeam AC Iso, LiteBeam AC, IsoStation AC, PrismStation AC, Rocket Prism AC and Rocket AC series) In this blog we will show you how to configure a transparent Ubiquiti Point to Multi Point bridge in the current version (8.4.2) of AirOS 8 using a Rocket 5AC Prism GEN2 as the AP Radio, a Nanobeam 5AC-Gen2 and Powerbeam 5AC-Gen2 as station/client radios.
0 kommentar(er)
